HYOSUNG 2010 ST7 Service Manual page 92

3-45 ENGINE
CAUTION
After the cam driven gear, cam guide, gearshift
shaft and neutral cam stopper have been fitted,
confirm that gear change is normal while turning
the countshaft and driveshaft. If gear change is
not obtained, it means that assembly of gears or
installation of gear shifting fork is incorrect. In
this case, disassemble and trace the mistake.
OIL PUMP
Before installing the oil pump, apply the engine oil to
the contact face of case, outer rotor, inner rotor and
shaft.
Apply a small quantity THREAD LOCK 1324 to the
oil pump securing screws.
THREAD LOCK 1324
Tighten the oil pump securing screws.
Install the oil pump shim and pin.
Put in the oil pump driven gear, and install the circlip.
CAUTION
When installing the oil pump to the crankcase,
turn the pump gear and check that rotation is
smooth by the hand.