REAR TIRE REPLACEMENT
●
1. Place the motorcycle on the jack or block.
�
�
2. Remove the mounting bolts, engine
pulley cover and drive belt case.
�
WARNING
A hot muffler can burn you.
The muffler will be hot enough to burn
you for some time after stopping the
engine.
Wait until the muffler cools to avoid
burns.
3. Loosen the drive belt adjuster ① , left and
right, and disengage the drive belt from
the rear pulley.
4. Loosen the rear axle bolt ② .
5. Draw out the rear axle shaft.
6. Pull the rear wheel assembly rearward.
7. To replace the wheel, reverse the com-
plete sequence listed.
REPLACEMENT OF THE LAMP
Requirement electric power of the lamp
shown in the following chart.
When replace the damaged lamp, always
use the equal capacity.
The use of a lamp other than specification
may cause the electric system or the lamp
to damage.
Head lamp
Brake / Tail lamp
Turn signal lamp
�
License plate lamp
※ LED : Light Emitting Diode
64
NAMES
HI
LO
CAPACITY
12V-60W× 1
12V-55W× 1
LED type
12V-10W× 4
12V-5W× 1