HYOSUNG 2010 ST7 Service Manual page 57

ENGINE PULLEY
Loosen the rear axle ① and belt adjusters ②, left
and right.
Install the engine pulley.
Tighten the engine pulley nut ③ to the specified
torque.
Engine pulley nut
: 130 ~ 160 N m (13.0 ~ 16.0 kgf m)
NOTE
W h e n t i g h t e n i n g t h e e n g i n e p u l l e y n u t ,
depress the rear brake pedal.
Bend the lock washer securely.
Install the gearshift arm and adjust the gearshift lever
height. (Refer to page 2-10)
Install the breather hose and engine pulley cover.
Connect each electric parts and its couplers.
(See pages 9-30 through 36)
Connect the all sensor and its couplers.
(Refer to chapter 4 and 5)
Install the exhaust pipes and mufflers.
Install the throttle body and air cleaner.
(Refer to page 5-8)
Install the radiator and radiator cover.
(Refer to page 6-4)
Af t e r r e m o u n t i n g t h e e n g i n e , t h e f o l l o w i n g
adjustments are necessary.
Engine idling speed inspect
Throttle cable play
Clutch cable play
Drive belt
Gearshift lever height
Engine oil level
Engine coolant
Refer to page 2-9
Refer to page 2-9
Refer to page 2-10
Refer to page 2-15
Refer to page 2-10
Refer to page 2-13
Refer to page 2-24
②
②
ENGINE 3-10
①
③