HYOSUNG 2010 ST7 Service Manual page 243

8-39 CHASSIS
REAR WHEEL SHOCK ABSOR-
BER
Inspect the rear wheel shock absorber for wear and
damage.
Replace the rear wheel shock absorber if there is any-
thing unusual.
REAR PULLEY
Inspect the pulley's teeth for wear. If they are worn,
replace the pulley and drive belt as a set.
REASSEMBLY AND REMOU-
NTING
Reassemble and remount the rear wheel in the reverse
order of removal and disassembly.
Pay attention to the following points :
Tighten the rear pulley bolts to the specified torque.
Rear pulley bolt
: 20 ~ 30 N m (2.0 ~ 3.0 kgf m)
With the rear wheel installed, tighten the rear axle ①
to the specified torque.
Rear axle
: 90 ~ 140 N m (9.0 ~ 14.0 kgf m)
①