HYOSUNG 2010 ST7 Service Manual page 221

8-17 CHASSIS
MASTER CYLINDER INSPEC-
TION
Inspect the master cylinder bore for any scratches or
other damage.
Inspect the piston surface for any scratches or other
damage.
MASTER CYLINDER REASS-
EMBLY AND REMOUNTING
Reassemble the master cylinder in the reverse order of
removal and disassembly.
Pay attention to the following points :
CAUTION
Wash the master cylider components with new
brake fluid before reassembly.
When washing the components, use the speci-
fied brake fluid. Never use different types of
fluid or cleaning solvents such as gasoline,
kerosine, etc.
Brake fluid specification and classification
NOTE
When installing the circlip, make sure that the
sharp edge of the circlip faces outside.
When remounting the master cylinder to the handle-
bars, first tighten the clamp bolts for upside as
shown.
WARNING
Bleed air from the brake fluid circuit after assem-
bling master cylinder. (Refer to page 2-20)
: DOT 4
Upper clamp bolt
"UP"
mark
Master Cylinder
Handlebar
Clearance