HYOSUNG 2010 ST7 Service Manual page 109

● When connecting meter probe from the terminal side
of the coupler (connection from harness side not
being possible), use extra care not to force and
cause the male terminal to bend or the female termi-
nal to open.
Connect the probe as shown to avoid opening of
female terminal.
Never push in the probe where male terminal is sup-
posed to fit.
● Check the male connector for bend and female con-
nector for excessive opening. Also check the coupler
for locking (looseness), corrosion, dust, etc.
⊙ ⊙ FUSE
● When a fuse blows, always investigate the cause to
correct it and then replace the fuse.
● Do not use a fuse of a different capacity.
● Do not use wire or any other substitute for the fuse.
⊙ ⊙ ECU / VARIOUS SENSORS
● Since each component is a high-precision part, great
care should be taken not to apply any sharp impacts
during removal and installation.
● Be careful not to touch the electrical terminals of the
ECU.
The static electricity from your body may damage this
part.
EI SYSTEM DIAGNOSIS 4-2