HYOSUNG 2010 ST7 Service Manual page 219

8-15 CHASSIS
Tighten the caliper mounting bolts and brake hose
union bolt ① to the specified torque.
Front brake caliper mounting bolts
: 18 ~ 28 N m (1.8 ~ 2.8 kgf m)
Front brake hose union bolts
: 20 ~ 25 N m (2.0 ~ 2.5 kgf m)
NOTE
Before remounting the caliper, push the piston all
the way into the caliper.
Install the caliper mounting bolt caps ②.
Fill the system with brake fluid and bleed air.
(Refer to page 2-20)
Inspection after reassembly : Refer to page 2-17
BRAKE DISK INSPECTION
Visually check the brake disk for damage or cracks.
Measure the thickness using the micrometer.
Replace the brake disk if the thickness is less than the
service limit or if damage is found.
Brake disk thickness
Micrometer (0 25 mm) : 09900-20201
Measure the runout using the dial gauge.
Replace the brake disk if the runout exceeds the service
limit.
Brake disk runout
Dial gauge : 09900-20606
Magnetic stand : 09900-20701
If measurement exceeds the service limit, replace the
brake disk. (Refer to page 8-8)
Service limit
3.0 mm (0.12 in)
Service limit
0.3 mm (0.012 in)
②
①