Iat Sensor Inspection - HYOSUNG 2010 ST7 Service Manual

⊙ ⊙ WT SENSOR INSPECTION
The water temperature (WT) sensor ① is installed at
the rear side of the thermostat case.
(Refer to page 4-33)
⊙ ⊙ WT SENSOR REMOVAL AND
INSTALLATION
● Remove the WT sensor.
● Install the WT sensor in the reverse order of
removal.
WT sensor : 5 ~ 8 N· · m (0.5 ~ 0.8 kgf· · m)
⊙ ⊙ IAT SENSOR INSPECTION
The intake air temperature (IAT) sensor ② is
installed at the downside of the air cleaner case.
(Refer to page 4-31)
⊙ ⊙ IAT SENSOR REMOVAL AND
INSTALLATION
● Remove the fuel tank.
● Remove the IAT sensor from the air cleaner case.
● Install the IAT sensor in the reverse order of
removal.
⊙ ⊙ RO SWITCH INSPECTION,
REMOVAL AND INSTALLA-
TION
The roll over (RO) switch ③ is located in the down-
side of the fuel tank mounting bolts.
● Romove the front seat.
● Remove the RO switch from the frame.
● Install the RO switch in the reverse order of
removal.
EI SYSTEM DIAGNOSIS 4-52
①
②
③