HYOSUNG 2010 ST7 Service Manual page 223

8-19 CHASSIS
REASSEMBLY AND REMOU-
NTING
Perform the reassembly and remounting work in the
reverse order of the removal and disassembly proce-
dures while observing the following instructions.
Install the punch mark ① of the handlebar aligned
with the handlebar clamp as shown.
Tighten the handlebar clamp bolts to the specified
torque.
Handlebar clamp bolts
: 18 ~ 28 N m (1.8 ~ 2.8 kgf m)
Install the handlebar clamp bolt caps.
When remounting the right and left handle switches,
engage the stopper ② with the handlebar hole ③.
Align the mating face of clutch lever holders with the
respective punch marks and tighten the bolt.
Install the brake master cylinder.
(Refer to page 8-17).
①
②
③