HYOSUNG 2010 ST7 Service Manual page 229

8-25 CHASSIS
⊙ ⊙ REASSEMBLY AND REMOUNTING
Reassemble and remount the front fork in the reverse order of removal and disassembly.
Pay attention to the following points :
Thoroughly wash all the component parts being assembled.
Insufficient washing can result in oil leakage or premature wear of the parts.
When reassembling the front fork, use new fork oil.
Use the specified fork oil for the front fork.
When reassembling, replace the oil seal, dust seal and damper rod bolt gasket with new ones.
● On the inner tube, assemble the following parts.
① Dust seal
② Oil seal stopper ring
③ Oil seal
④ Oil seal retainer
⑤ Slide metal
⑥ Guide bushing
CAUTION
To prevent the lip of oil seal ③ ③ from being dam-
aged, cover the inner tube with vinyl sheet
during installation.
● With the oil lock piece fitted to the inner tube, assem-
ble the inner tube to the outer tube.
● Apply SUPER GREASE A to the lip of the oil seal
and install it into the outer tube using the front fork
oil seal installer.
SUPER GREASE " " A" "
Front fork oil seal installer set
CAUTION
Wash and clean the front fork oil seal installer
before using. If dirt is on the installer, the inner
tube may possibly be damaged during press-fit-
ting work.
CAUTION
: 09940-52861
③
④
⑤
⑥
①
②