HYOSUNG 2010 ST7 Service Manual page 95

Install the clutch release rack ①, bearing ② and
washer ③.
Install the clutch pressure plate ④ retainer, clutch
springs and clutch spring mounting bolts.
Hold the primary drive gear nut and tighten the clutch
spring mounting bolts in a crisscross pattern.
NOTE
Make sure that the clutch pressure plate is
installed correctly.
CLUTCH COVER
Install the two dowel pins ⑤ and new gasket ⑥
Apply engine oil to each gears, bearings and clutch
plates.
④
⑤
ENGINE 3-48
③
①
②
⑥
⑤