HYOSUNG 2010 ST7 Service Manual page 82

3-35 ENGINE
REASSEMBLY
Drive in the oil seal using the special tool.
Bearing installer : 09913-75820
Install the circlip.
CLUTCH DRIVE PLATES
Measure the thickness and claw width of the clutch drive
plates using vernier calipers. If a clutch drive plate is not
within the service limit, replace the clutch plates as a
set.
Clutch drive plate
NO.1
thickness
NO.2
Clutch drive plate
NO.1
thickness
NO.2
Clutch drive plate
NO.1
claw width
NO.2
Clutch drive plate
NO.1
claw width
NO.2
Vernier calipers : 09900-20101
CLUTCH DRIVEN PLATES
Measure each clutch driven plate for distortion using
the thickness gauge. If a clutch driven plate is not within
the service limit, replace the clutch plates as a set.
Clutch driven plate
distortion
Thickness gauge : 09900-20806
Standard
2.92~3.08 mm (0.115~0.121 in)
3.42~3.58 mm (0.135~0.141 in)
Service limit
2.62 mm (0.103 in)
3.12 mm (0.123 in)
Standard
15.9~16.0 mm (0.626~0.630 in)
15.9~16.0 mm (0.626~0.630 in)
Service limit
15.1 mm (0.595 in)
15.1 mm (0.595 in)
Service limit
0.1 mm (0.004 in)