HYOSUNG 2010 ST7 Service Manual page 96

3-49 ENGINE
Install the clutch cover, and tighten the clutch cover
bolts securely.
Install the clutch release arm as following :
① Turn the clutch release shaft toward(This time,
mark on the shaft align outside contact line the
stopper screw) the right.
② Install that the release camshaft notch mark align
matching mark of the crankcase as shown in the
right figure.
OIL DRAIN PLUG
Tighten the oil drain plug to the specified torque.
Engine oil drain plug
STATOR
Apply a small quantity of THREAD LOCK 1324
to the threaded parts of screws.
THREAD LOCK 1324
STARTER CLUTCH
When installing the starter clutch and rotor, apply the
THREAD LOCK 1324 to the bolts and tighten to
the specified torque.
THREAD LOCK 1324
Starter clutch bolt
: 23 ~ 28 N m (2.3 ~ 2.8 kgf m)
: 21 N m (2.1 kgf m)