HYOSUNG 2010 ST7 Service Manual page 218

CALIPER REASSEMBLY
AND REMOUNTING
Reassemble and remount the caliper in the reverse
order of removal and disassembly procedures and
observe the following points.
CAUTION
Wash the caliper components with fresh brake
fluid before reassembly. Do not wipe off brake
fluid after washing the components.
When washing the components, use the speci-
fied brake fluid. Never use different types of
fluid or cleaning solvent such as gasoline,
kerosine or the others.
Replace the piston seal and dust seal into new
ones with brake fluid applied.
Brake fluid specification and classification
Install the dust seal and piston seal as shown in the
right illustration.
Install the O-ring ① and put caliper halves together.
Tighten the caliper housing bolts ② to the specified
torque.
Front brake caliper housing bolt
: 40 ~ 45 N m (4.0 ~ 4.5 kgf m)
: DOT 4
①
②
②
CHASSIS 8-14