Module Wiring Warnings; Figure 52 Process Map: Trunk And Station Wiring Process Map - Nortel BCM1000 Installation And Maintenance Manual

134 Chapter 10 Wiring the modules

Figure 52 Process map: Trunk and station wiring process map

Trunk and station modules
Media bay modules installed.
Read warnings
Wire cables to telco
demarcation block
Connect cables
appropriate trunk modules.
Wire internal 25-pair cables
to station set distribution BIX
block for your building
Connect amphenol cable
appropriate station modules

Module wiring warnings

Warning: Electrical shock warning.
The Business Communications Manager media bay modules have been Safety approved
for installation into BCM1000 and BCM1000e. It is the responsibility of the installer and
user to ensure that installation of the Business Communications Manager hardware does
not compromise existing Safety approvals.
BEFORE YOU OPEN the BCM1000 or BCM1000e ensure that the cables are unplugged
from the front of the unit, and the unit is disconnected from the ac power source.
Station modules: The ports on these modules are meant to be connected only to approved
digital telephones and peripherals with the proper cables on a protected internal system.
Do not connect any telephones to wiring that runs outside of the building.
Read and follow the installation instructions carefully.
N0008587 01
to
to
Continue with setup procedures