Installing A Media Bay Module; Figure 43 Removing The Front Bezel; Figure 44 Identifying The Media Bay Module Latches - Nortel BCM1000 Installation And Maintenance Manual

Installing a media bay module

After the system is powered down, you can install and remove media bay modules, as required.
Follow these procedures to install a media bay module. Reverse the procedure to remove modules.
Ensure that the switches on the media bay module are set correctly. For information about how
1
to set the switches, refer to
In the case of FEM modules, the switches activate the front ports. Ensure that the switches
accurately reflect the ports you require. Refer to
Remove the front bezel from the unit where you want to install or remove the module by
2
grasping the edges and pulling forward. Refer to

Figure 43 Removing the front bezel

Select an open media bay.
3
Pull the latch beside the selected bay to release the media bay bezel. Refer to
4

Figure 44 Identifying the media bay module latches

Chapter 7, "Setting media bay module DIP switches," on page
BCM1000e
Chapter 8 Installing media bay modules
"FEM switch settings" on page
Figure 43.
BCM1000
Grasp the edge of the front bezel and pull
it forward
BCM1000
media bay module latches
Installation and Maintenance Guide
108.
1. Push against the bottom
2. Pull out from the top
Figure 44.
BCM1000e
111
85.