Table 10 Matching Modules To Ds30 Bus Capacity - Nortel BCM1000 Installation And Maintenance Manual

Note: If you Choose a CTM8 or a 4X16 module, there are some restrictions about the
offsets you can choose. Refer to the DIP switch settings in
on page 95 and
Make a list of modules and the space requirements for each module you chose.
1
Refer to Table 10.

Table 10 Matching modules to DS30 bus capacity

Channel split 2/6 (default) _____
Type of module
Set the bus numbers and offsets on the DIP switches of the module. Refer to
2
"Setting media bay module DIP switches," on page
starting from the bottom DS30 bus, and you assign station modules starting from the top DS30
bus.
Install the modules into the BCM1000 or BCM1000e. Refer to
3
bay modules," on page
Chapter 4 Selecting the media bay modules for your system
"4X16 switch settings" on page 99
3/5 (extra IP lines) _____
Number required
109.
"CTM/GATM switch settings"
for details
DS30 bus/offsets required
85. Note that you assign trunk modules
Chapter 8, "Installing media
Installation and Maintenance Guide
67
Chapter 7,