Figure 58 Wiring For An Asm 8 Or Gasm8; Table 35 Asm Wiring Chart - Nortel BCM1000 Installation And Maintenance Manual

140 Chapter 10 Wiring the modules
Table 35 and Figure 58
Plug the female amphenol connector into the interface on the front of the module.
3

Figure 58 Wiring for an ASM 8 or GASM8

25-pair female
amphenol
26R
connector
WARNING: Ensure that you have Tip (T) and
Ring (R) connected to the appropriate pins.
Note: Refer to
relationship between the DS30 bus number and the DNs. Configuration information is
included in the chapters on setting up modules and DNs in the Business Communications
Manager Programming Operations Guide.
Set up any mobile system you are using.
4
• Ensure the base stations are correctly installed and connected to the appropriate modules
on the Business Communications Manager hardware. In the case of the Wireless LAN IP
telephone system, ensure that the access point is correctly set up to connect to the
BCM1000 LAN or WAN.
• Configure and register the handsets according to the instructions provided for each type of
system.
— Digital Mobility Installation and Configuration Guide
— Wireless LAN IP Telephone Installation and Configuration Guide
— T7406: T7406 Cordless Handset Installation Guide
N0008587 01
provide the wiring scheme for the eight pairs that connect to an ASM.
5T
2T 7T
4T
1T 3T
6T
30R
32R
28R
31R
29R
27R
"Line and extension numbers for specific modules" on page 93

Table 35 ASM wiring chart

Pin Wire color
26 White-Blue
1 Blue-White
27 White-Orange
2 Orange-White
28 White-Green
8T
33R 3 Green-White
29 White-Brown
4 Brown-White
30 White-Slate
5 Slate-White
31 Red-Blue
6 Blue-Red
32 Red-Orange
7 Orange-Red
33 Red-Green
8 Green-Red
34-50 no connection
9-25
Port Set
X01 1
X01 1
X02 2
X02 2
X03 3
X03 3
X04 4
X04 4
X05 5
X05 5
X06 6
X06 6
X07 7
X07 7
X08 8
X08 8
to see the