Table of Contents
Advertisement
Replace the cover on the BCM1000.
5
Restore the units to operation. Refer to
6
Perform the procedure appropriate for the type of hard disk system you have:
7
•
Single disk: Initialize the hard disk. Refer to
system, BCM 2.5/2.5.1)" on page
After the disk is initialized, restore your data from your backups. If you did not backup
your keycodes, re-enter them.
•
Mirrored disks: The system automatically starts the mirroring process. Monitor the
progress of the mirroring task using the Mirroring diagnostics tool in the Unified Manager
(refer to
Telnet.
The LEDs on the front of the RAID board indicate the current status of the board and the
hard disks. For more information, refer to
Initializing the hard disk (single-disk system, BCM 2.5/2.5.1)
The BCM1000 is normally initialized at the factory. However, if you have to replace the hard drive
in a single-disk BCM1000, you must re-initialize the Business Communications Manager.
After you replace the hard disk and the system has booted up, perform the initialization as follows:
Make sure the Status LED on the BCM1000 is lit. This LED indicates that the Business
1
Communications Manager is operating correctly.
Attach the base unit and a computer through the serial port, as described in
2
modem cable" on page
Enter the terminal emulation program, as described in
3
page
128,
• If the hard disk does not require initialization, the main menu appears. Refer to
Figure 83 Main Menu screen
"Controlling and monitoring mirroring operations" on page
127.
Chapter 16 Replacing the hard disk
"Restarting the system" on page
"Initializing the hard disk (single-disk
179.
"RAID board LEDs" on page
"Finding the configuration menus" on
Installation and Maintenance Guide
179
170.
196) or by using
195.
"Setting up the null
Figure
83.
Advertisement
Table of Contents
Troubleshooting
