Figure 94 Quick Start Page - Nortel BCM1000 Installation And Maintenance Manual

188 Chapter 16 Replacing the hard disk

Figure 94 Quick start page

12 Enter the correct information for LAN1 (a), LAN2 (i), Subnet masks (m and j), Default next
hop router (r) and System name (s), as required. Enter p after each change to apply it.
13 Enter b (go back) to return to the System Configuration Start Page screen after all network IP
addresses are configured.
14 Enter r to reboot the system and to apply the network IP address changes
15 Do one of the following:
• Run the Quick Start Wizard and manually reconfigure your system.
• Run the Quick Start Wizard to create the system parameters and defaults. Then restore
your system data from your backup disk.
• Restore system and data information from your backup disk.
Warning: You can only perform a restore from a current backup disk that was backed up
from the same software version as your system is currently running. If you do not have a
current backup run on this version of software, you need to manually reenter your data.
16 Test your system for correct operations.
N0008587 01