Figure 30 Attaching The Mounting Brackets To The Bcm1000 - Nortel BCM1000 Installation And Maintenance Manual

Figure 30 Attaching the mounting brackets to the BCM1000

Install the 2 cm (3/4 in.) plywood backboard on the wall.
3
Insert two #10 x 2.5 cm (#10 x 1 in.) round-head wood screws in the backboard. The screws
4
must be 34.5 cm (13.5 in.) apart and level.
Do not tighten the screws heads against the backboard. Leave approximately 0.5 cm (0.25 in.)
of the screw out of the backboard.
Note: Position the screws to leave enough space beside the BCM1000 (23 cm or 9 in.) to
insert and remove the media bay modules.
Hang the base unit on the two screws, using the outer slotted holes.
5
Make sure the base unit is level, the mounting brackets are against the wall, and the front cover
is facing left or right. Refer to
Rack mount brackets
Figure 31.
Chapter 5 Installing the BCM1000
Wall mount brackets
Installation and Maintenance Guide
75