Table of Contents
Advertisement
Chapter 5
Configuring the R2MFC MBM
Trunk protocol conversion provides interworking between two different trunk protocols, and
requires configuration for the following:
•
E1- MFCR2
•
E1- ETSI Euro-PRI
The MFCR2 is the external interface. The external interface connects to a public network. The
R2MFC MBM contains preprogrammed country-specific MFCR2 settings that can be selected
using the DIP switches on the faceplate of the R2MFC MBM. The MFCR2 settings can also be
customized. The PRI is an internal link to the BCM. The PRI setting are configured to predefined
settings when the region is selected during BCM initialization. The PRI does not require
customization, but it must be configured as detailed in
page
52.
This chapter lists the configurable parameters of both the MFCR2 side and the PRI side of the
R2MFC MBM, and explains how to configure them.
configuration process.
Figure 16 Configuring the R2MFC MBM
Install the
R2MFC MBM
Determine the correct
configuration
parameters for the
external link
"Configuring the PRI (internal) link" on
Figure 16
Does the
setup require custom
settings?
NO
Set Config DIP switches
R2MFC Media Bay Module Installation and Configuration Guide
provides an overview of the
Create a new
YES
customized country
code
Determine the correct
configuration
parameters for the
internal link
Configure the internal
PRI link through
Element Manager or
Unified Manager
45
Advertisement
Table of Contents
