Nortel R2MFC Installation And Configuration Manual page 44

44 Chapter 4 Installing the R2MFC MBM
3
Attach the transmit BNC cable to the connector labeled Tx and the receive BNC cable to the
connector labeled Rx, for countries using BNC connections. Insert the connector into the RJ48
jack on the module, for countries using the RJ48 connections.
wiring pinouts for an R2MFC MBM to connect to a service provider using RJ48 connectors.
Warning: If you are using a service provider channel service unit (CSU), you must
disable the Business Communications Manager system internal CSU by using Business
Communications Manager Unified Manager. For more information, refer to the
Programming Operations guide for the host system.
4
Use the Element Manager to configure the lines or sets associated with the module. Refer to
the BCM Programming Operations guide for the host system for more information.
Refer to the BCM Programming Operations guide for the host system for information on
changing the default settings for each line/loop.
NN40010-300
Figure 14 on page 41 shows the