Table of Contents
Advertisement
48
Chapter 5 Configuring the R2MFC MBM
End of dialing (incoming)
End of dialing for an incoming call can be configured by using the CLI. See
dialing options.
Table 3 Minimum (or fixed) number length + timer parameters
Option
Explicit 'End of dial' signal
(I-15)
Minimum (or fixed) number
length and timer
Minimum (or fixed) number
length and timer
Minimum (or fixed) number
length and timer
Minimum (or fixed) number
length and timer
End of dialing (outgoing)
End of dialing in outgoing calls is indicated by MFC signal "I15" (or equivalent country-specific
signal). This signal is sent if the far-end requests next digit beyond the last digit of the dialed
number.
When R2MFC MBM originates a call to the CO, the R2MFC MBM has already received the
whole dialed number from the BCM. This is because the digits are passed from BCM to the MBM
by PRI "en-bloc." This operation mode means that BCM determines user end-of-dialing either by
number of digits, explicit input from user (for example, the "#" digit), or timeout.
Disable ANI
The ANI request option can be disabled. When disabled:
•
Incoming call — R2MFC MBM does not request ANI.
•
Outgoing call — When far end requests ANI, R2MFC MBM answers "ANI not available."
NN40010-300
Parameters
None
Minimal number of digits
Optional number of additional
digits
Interdigit timer in the minimal
interval (long timer)
Interdigit timer in the optional
interval (short timer)
Table
Meaning
The preset option for all
countries. However, signal
has low significance, because
the end of dialing is
determined by the BCM (PRI
side) when it receives the last
digit of the number.
Receiving minimum number of
digits + optional number of
digits means end of dial
(maximum length reached)
When a fixed length number is
always expected, set the
optional number of digits to 0.
Expiry of the long timer means
MFC error - number
incomplete.
Expiry of the short timer
means end of dial.
3, for the end of
Default
Yes
No
No
No
No
Advertisement
Table of Contents
