Table of Contents
Advertisement
Table 21 CNtrl directory CLI commands (Sheet 3 of 3)
CLI command
CoNlm <chan>
CoNlmGrp <start_chan>
<end_chan>
MC <link_num>
COnfig directory
Table 22 includes the CLI commands for general card configuration. The commands are accessed
from the COnfig directory.
Table 22 COnfig directory CLI commands (Sheet 1 of 2)
CLI command
LinePhy <phy_mode>
SaveCfg
Description
Transfers the channel to an online state.
Where:
chan is the channel number in the range of 1...15, 17...31.
If the system accepts the message, the channel becomes disabled. This
command sends a message to both protocol handlers.
Transfers a group of channels to an online state.
Where:
start_chan is the first channel in the group.
end_chan is the last channel in the group.
The values for start_chan and end_chan are 1...15, 17...31.
If the system accepts the messages, the channels become disabled.
Sets the side that is used as clock source.
Where:
link_num is either 0 (link 0) or 1 (link 1).
If this command is entered without a parameter, the current clock master is
printed.
Description
Sets the physical interface type of the external E1 line.
Where phy_mode can be:
0 indicating 120 Ohm (RJ48 connector).
1 indicating 75 Ohm (RX and TX, BNC connector), grounded shield.
2 indicating 75 Ohm (TX BNC connectors), not-grounded shield.
Stores the current configuration on non-volatile Flash memory.
All parameters are stored-country-specific and non-country-specific. The
stored configuration is used when the config DIP switches on the faceplate
are set to custom profile. Only one configuration (custom profile) is stored.
This command deletes the previous configuration contents.
R2MFC Media Bay Module Installation and Configuration Guide
Chapter 7 Command Line Interface (CLI) 79
Advertisement
Table of Contents
