Power connectors
The R2MFC MBM receives its power from the BCM chassis through a power connector on the
back of the module.
Figure 4
shows the placement of the power connectors.
Figure 4 R2MFC MBM back
MBM DIP switches
There are DIP switches located on the underside of the R2MFC MBM. These DIP switches are
used to select the DS30 buses from the DS256 bus. These DIP switches must be set before the
R2MFC MBM is installed.
Figure 5
shows the location of the DIP switches.
Figure 5 DIP switch location on the
Back of the R2MFC MBM
DS256 and
power connector
R2MFC MBM
R2MFC Media Bay Module Installation and Configuration Guide
Underside of the R2MFC
6 5 4 3 2 1
DIP switches
Chapter 2 Overview
Off
On
25