Table of Contents
Advertisement
38 Chapter 4 Installing the R2MFC MBM
Reconnecting the equipment
After you install the module correctly into the bay, you must return the equipment to operation.
Caution: Complete the following steps carefully to ensure you return your
system to operation without endangering the equipment or yourself.
1
Plug the power cords for the BCM and any expansion units back into the AC outlets.
2
Connect the cables to the proper outlets on the R2MFC MBM and the MSC on the BCM.
3
Check that the LEDs on the newly installed R2MFC MBM are on and indicating the correct
state. Refer to
4
Confirm that the BCM is functioning properly by testing to make sure it works the same as it
did before installing the R2MFC MBM.
5
Configure the module. Refer to
details.
Removing an R2MFC MBM
Follow the procedures in this section to remove an R2MFC MBM from a BCM platform base
chassis or expansion unit.
Figure 10
provides an overview of the process for removing an R2MFC MBM.
Figure 10 Overview of removing an R2MFC MBM
NN40010-300
Note: The Business Communications Manager system starts up when you
connect the AC power cord. System startup takes several minutes to complete.
"Faceplate LEDs" on page 66
Chapter 5, "Configuring the R2MFC MBM," on page 45
Shut down BCM and
Disconnect power from
Remove module cables
Remove module
for a detailed description of the LED states.
expansion unit
both units
for
Advertisement
Table of Contents
