Nortel R2MFC Installation And Configuration Manual page 78

78 Chapter 7 Command Line Interface (CLI)
Table 21 CNtrl directory CLI commands (Sheet 2 of 3)
CLI command
CEnbl <chan>
CEnblGrp <start_chan>
<end_chan>
LSd
LId
LEnbl
CoFlm <chan>
CoFlmGrp <start_chan>
<end_chan>
NN40010-300
Description
Performs channel enabling.
Where:
chan is the channel number in the range of 1...15, 17...31.
This command sends a message to both protocol handlers.
Performs channel enabling on a group of channels.
Where:
start_chan is the first channel in the group.
end_chan is the last channel in the group.
The values for start_chan and end_chan are 1...15, 17...31.
Performs link soft-disabling, which disables IDLE channels immediately.
If there is a call in progress, the system disables the channel after the
current call is complete. This command sends a message to both protocol
handlers.
Performs immediate link disabling.
If there is a call in progress, the system ends the call and disables the
channel. This command sends a message to both protocol handlers.
Performs link enabling.
The command sends a message to both protocol handlers.
Transfers a disabled channel to an offline state.
Where:
chan is the channel number in the range of 1...15, 17...31.
The command sends a message to both protocol handlers.
Transfers disabled channels to an offline state.
Where:
start_chan is the first channel in the group.
end_chan is the last channel in the group.
The values for start_chan and end_chan are 1...15, 17...31.
The command sends messages to both protocol handlers.