Load Directory; Info Directory - Nortel R2MFC Installation And Configuration Manual

Commands
The following section lists and describes the CLI commands for the available directories.

LOad directory

Table 18 includes the CLI commands for firmware download and card restart. The commands are
accessed from the LOad directory.
Table 18 LOad directory CLI commands
CLI command
RST
load y
fload

INfo directory

Table 19 includes the CLI command to display and print information for troubleshooting problems
in the field. The command is accessed from the INfo directory.
Table 19 INfo directory CLI commands
CLI command
Fwversion
SystTime
ALarm
ChannelSummary
Description
Restarts card firmware regardless of current state.
There is no prompt to confirm the restart.
Configures the hardware to accept downloads
Downloads the firmware.
Description
Displays the firmware versions and the state of the DIP switches.
Prints the current time and how long the load has been in-service.
Prints the status of the E1 alarms on both links.
Prints a summary of all PRI and MFC channels currently in use; for example,
not in idle state
R2MFC Media Bay Module Installation and Configuration Guide
Chapter 7 Command Line Interface (CLI) 75