The Reversing Lamp Is Inoperative - Ford 2002 Bantam Workshop Manual

BACK TO CHAPTER INDEX
417-01-61
DIAGNOSIS AND TESTING
Reversing Lamps
Inspection and Verification
1. Verify the customer concern.
2. Visually inspect for obvious signs of
mechanical or electrical damage.
Visual Inspection Chart
• Fuse(s).
• Bulb(s).
• Wiring harness.
• Electrical connector(s).
Symptom Chart
Symptom Chart
Condition
• The reversing lamp is inopera-
tive.
• The reversing lamp is on con-
tinuously.
Pinpoint Tests
PINPOINT TEST Q: THE REVERSING LAMP IS INOPERATIVE
Q1: CHECK THE FUSE F13
E6755 EN
Electrical
• Fuse.
• Circuit(s).
• Reversing lamp.
• Transmission switch.
• Circuit(s).
• Transmission switch.
CONDITIONS
1. 2.
Fuse F13 (CJB)
Exterior Lighting
3. If an obvious cause for an observed or
reported concern is found, correct the cause
(if possible) before proceeding to the next
step.
4. If the cause is not visually evident, verify the
symptom and refer to the Symptom Chart.
Possible Sources
DETAILS/RESULTS/ACTIONS
3 Check the fuse F13 (15 A).
• Is the fuse OK?
Yes
GO TO Q2
No
INSTALL a new fuse F13 (15 A). If the fuse
blows again, LOCATE and REPAIR the
short circuit by using the wiring diagrams.
TEST the system for normal operation.
FORD BANTAM PAGES FROM MANUAL
TO MODEL INDEX
Action
• Go To Pinpoint Test Q
• Go To Pinpoint Test R
CONTINUED
07/2001 2002 Bantam
417-01-61