Headlamp Adjustment - Ford 2002 Bantam Workshop Manual

BACK TO CHAPTER INDEX
417-01-75
GENERAL PROCEDURES

Headlamp Adjustment

General Equipment
Headlamp beam setting equipment
E6758 EN
Exterior Lighting
Adjustment
1. Before starting the headlamp adjustment:
• Place the vehicle on a level surface.
• Check the correct headlamp operation,
and renew damaged components as
necessary.
• Check the tyre inflation.
• Check that no other load is in the vehicle
other than a half tank of gas.
• Set the measuring screen of the beam
setting equipment to the following
headlamp adjustment value (X): X=10
cm/10 m=0 degrees 34 minutes=1.0%.
2. Adjust the low beam.
• Switch on the low beam.
1. Vertical alignment screw.
2. Horizontal alignment screw.
3. Vertical adjustment.
• Adjust the low beam so that the
light/dark boundary touches the horizontal
line.
FORD BANTAM PAGES FROM MANUAL
TO MODEL INDEX
CONTINUED
07/2001 2002 Bantam
417-01-75