Ford 2002 Bantam Workshop Manual page 1162

412-02-10
REMOVAL AND INSTALLATION (CONTINUED)
E1246 EN
Heating and Ventilation
NOTE: Plug the heat exchanger.
9. Pull off the connector and detach the
coolant hoses.
1. Disconnect the plug from the heater
regulating valve.
2. Undo the clamps and disconnect the
coolant hoses.
10. Separate the connectors.
1. Blower motor
2. Air re-circulation valve control motor
3. Blower motor resistor assembly
11. Remove the heater.
• Pull off the side air ducts.
1. Unscrew the three nuts.
• Undo the wiring harness.
2. Undo the heater from the bracket.
Vehicles with air conditioning
12. Pull off the air conditioning condenser drain
hose.
Installation
NOTE: Torques For additional information,
refer to Section 412-02, Specifications
NOTE: Before connecting the refrigerant lines,
fit them with new O-rings. Coat the new O-rings
with refrigerant oil before fitting them.
1. Refit the components in the reverse order.
412-02-10
07/2001 2002 Bantam