Troubleshooting; Standards And Adjustments; Adjusting The Folding Position - Panasonic DP-C305 Service Manual

12.1.5. Troubleshooting

12.1.5.1. Standards and Adjustments

12.1.5.1.1. Electrical System (Finisher / Saddle Unit)

1. Adjusting the Folding Position

The folding position is adjusted by matching it with the stapling position.
IF you have replaced the Finisher Controller PCB, you must transfer the existing settings to the new
PCB. Perform the following if the folding position must be adjusted for some reason.
Caution:
Both the folding and stapling positions may deviate for some type of paper. In such a case, change
the "Fold Position" in the User Mode, located in the General Settings, Key Operator Mode,
Parameters No. 40 through 42 of the Host Machine.
1) Set SW1 on the Finisher Controller PCB as follows :
2) Adjust the folding position by pressing the PSW1 or PSW2 on the Finisher Controller PCB a
required number of times. Pressing the switch once moves the folding position about 0.16mm.
• To move the folding position in the "-" direction, press the PSW1.
• To move the folding position in the "+" direction, press the PSW2.
• Turn on Points 1, 4 and 8 of SW1 on the circuit board first, and then press PSW1 and PSW2 at
once, and settings can be cleared.
3) When adjustment of the folding position is complete, set all bits of the SW1 on the Finisher
Controller PCB to OFF.
4) Enter the bind mode of the Host Machine and check whether the folding position is adjusted
properly. If adjusted improperly, adjust the folding position again (Adjustable range ±5 mm).
Ver. 1.1
ON
1 2 3 4 5 6 7 8
Fig. 5-001
- direction + direction
Fig. 5-002
841
DP-C405/C305/C265
FEB 2008