Adjusting The Middle 2-Point Stapling Position - Panasonic DP-C305 Service Manual

2. Adjusting the Middle 2-Point Stapling Position (Adjustment area : ±5 mm)
The stapling position is adjusted by matching it with the folding position.
If you have replaced the Finisher Controller PCB, you must transfer the existing settings to the new
PCB. Perform the following if the stapling position must be adjusted for some reason.
Caution:
Both the folding and stapling positions may deviate for some type of paper.
In such a case, change the "Fold Position" in the User Mode, located in the General Settings, Key
Operator Mode, Parameters No. 40 through 42 of the Host Machine.
1) Set SW1 on the Finisher Controller PCB as follows :
2) Adjust the stapling position by pressing the PSW1 or PSW2 on the Finisher Controller PCB a
required number of times. Pressing the switch once moves the stapling position about 0.14mm.
• To move the stapling position in the "-" direction, press the PSW1.
• To move the stapling position in the "+" direction, press the PSW2.
• Turn on Points 1, 4 of SW1 on the circuit board first, and then press the PSW1 and PSW2 at the
same time clears the adjustment value.
3) When adjustment of the stapling position is complete, set all bits of the SW1 on the Finisher
Controller PCB to OFF.
4) Enter the bind mode of the Host Machine and check whether the stapling position is adjusted
properly. If adjusted improperly, adjust the stapling position again.
Ver. 1.1
ON
1 2 3 4 5 6 7 8
Fig. 5-003
- direction + direction
Fig. 5-004
842
DP-C405/C305/C265
FEB 2008