Panasonic DP-C305 Service Manual page 644

14. Press the "Reset" key twice on the Control Panel to exit to the initial screen of the F2 Service Mode.
15. Press the "Function", and the "C (Clear)" keys simultaneously on the Control Panel.
8.5.3. Color Exposure (Special Adjustment for Customer's Requirement)
1. Press the "Function", "Copy", and the "3" keys simultaneously on the Control Panel.
2. Input the password, and select the "OK" button to enter the Service Mode (default password is
00000000).
3. Press the "2" key on the Control Panel, and then press the "Start" key to enter the F2 Service Mode.
4. Select "Quality Adj" on the Touch Panel display, and then set the Density to the center position.
Select "Full Color", "Text/Photo", "Commercial", and then select the "OK" button to set the
machine to Color T/ P Density.
5. Make a copy of Color Test Chart 101 (P/N PJQRC0119Z : LDR, PJQRC0120Z : A3), or the Customer's
Document and verify the density.
6. Press the "Reset" key twice on the Control Panel to exit to the initial screen of the F2 Service Mode.
7. Press the "6" key on the Control Panel, and then press the "Start" key to enter the F6 Service Mode.
8. Enter F6-211 Color T/P Density (lt) Mode.
9. Select "Input" on the Touch Panel display.
10. Enter the new 2-digit value.
Note:
The "Reset" key is used to enter a "-" (negative) value.
(+) : Lighter
(-) : Darker
11. Select the "OK" button on the Touch Panel display, and then select the "Close" button.
12. Press the "2" key on the Control Panel, and then press the "Start" key to enter the F2 Service Mode.
13. Make a copy to confirm the adjustment.
Note:
Repeat Step 4. to 13. until desired density is attained.
<Light Part Adjustment>
F6-210 : Color Text Density (lt)
F6-212 : Color Photo Density (lt)
<Dark Part Adjustment>
F6-215 : Color Text Density (dk)
F6-216 : Color T/P Density (dk)
F6-217 : Color Photo Density (dk)
14. Press the "Reset" key twice on the Control Panel to exit to the initial screen of the F2 Service Mode.
15. Press the "Function", and the "C (Clear)" keys simultaneously on the Control Panel.
8.5.4. User Authentication, and/or Via Fax Server Function Confirmation
(
Specified Destinations only
If your customer requires User Authentication and/or Via Fax Server, setup the feature(s) by referring to the
Operating Instructions (For User Authentication) for the PU (USA/Canada, etc.).
Note:
For other destinations below, set the Fax Service Mode 1 Function Parameter #005 (Destination Code)
by following the steps below.
000 : Austria
011 : Australia
1. Press the "Function", "Copy", and the "3" keys simultaneously on the Control Panel.
2. Input the password, and select the "OK" button to enter the Service Mode (default password is
00000000).
Ver. 1.1
)
001 : UK 006 : Germany
021 : France 022 : New Zealand
009 : Spain
644
DP-C405/C305/C265
FEB 2008