Binary Signal - Panasonic DP-C305 Service Manual

5.2.5. Fax Service Mode 4 (Modem Test)
5.2.5.1.

Binary Signal

This Service Mode is used to check the binary signal output. Signals can be output to the line using the
following procedure.
Set the machine to Service Mode, and press the "9" key on the Control Panel.
↓
Press the "Start" key to enter the F9 Service Mode on the Control Panel.
↓
Select "00 Fax Service Mode" on the Touch Panel display.
↓
Select "04 Modem tests" on the Touch Panel display.
↓
Select "01 Binary Signal" on the Touch Panel display.
↓
Select the desired parameter on the Touch Panel display, and then press the "Start" key on the Control
Panel.
↓
Press the "Stop" key on the Control Panel.
↓
Select the "Close" button three time on the Touch Panel display.
↓
Press the "Function", and the "C (Clear)" keys simultaneously on the Control Panel to exit the Service
Mode.
Ver. 1.1
Binary Signal Table
Signals
V21 300bps
V27ter 2400bps
V27ter 4800bps
V29 7200bps
V29 9600bps
V17 TC7200bps
V17 TC9600bps
V17 12000bps
V17 14400bps
579
DP-C405/C305/C265
FEB 2008