Panasonic DP-C305 Service Manual page 447

Code
U7 Close Right Cover Lower
(Feed Cover2/Feed Cover(Option))
U8 Close Paper Transport Unit
U11 Remove Paper in Finisher
U12 Close Finisher Staple Cover / Upper
Cover
No Punch Dust Box
U13-1 No Toner or Low Toner (Y)
U13-2 No Toner or Low Toner (M)
U13-3 No Toner or Low Toner (C)
U13-4 No Toner or Low Toner (BK)
U14 Replace Toner Waste Container
U15 No Toner Waste Container
U16 No Developer Unit
(Y, M, C, BK)
U18 Total Copy Limit Over
U20 Close ADF Cover
U21 Close ADF
U25 Toner Cartridge Motor Rotation Error
(Y, M, C, BK)
U27 No Fuser Unit
U28 No Drum Unit
(Y, M, C, BK)
U29 Replace Drum Unit
(Y, M, C, BK)
U30 Close Punch Cover
(Upper/Front Cover)
Ver. 1.1
User Error Codes (U Code) Table
Item Check Points
1. Right Cover is open.
2. Right Cover Sensor is disconnected.
3. Right Cover Sensor is defective.
4. LVPS connector is disconnected.
5. LVPS is defective.
6. EC PCB connector is disconnected.
7. EC PCB is defective.
1. Paper Transport Unit open.
2. Paper Transport Unit Sensor disconnected.
3. LVPS connector disconnected.
4. LVPS defective.
5. EC PCB connector disconnected.
6. EC PCB defective.
1. Paper left in the Finisher.
2. Finisher Paper Exit Sensor defective.
1. Close Finisher Staple Cover.
2. Finisher Staple Cover Sensor is disconnected.
3. Finisher Staple Cover Sensor is defective.
4. Punch Dust Box is not installed (DA-FS405/FS356/
FS325 only).
1. Toner Cartridge is not installed correctly.
2. No or Low Toner.
3. EC PCB connector is disconnected.
4. EC PCB is defective.
5. Hopper Unit is not installed correctly.
1. Toner Waste Container is full.
(See Section 9.18.)
1. Toner Waste Container is not installed.
2. Toner Waste Container Sensor is disconnected.
3. Toner Waste Container Sensor is defective.
1. Developer Unit is not installed.
1. Department Copy Counter is full.
1. ADF Cover is open.
2. ADF is not installed correctly.
3. ADF Cover Sensor is disconnected.
4. ADF Cover Sensor is defective.
5. LVPS connector is disconnected.
6. LVPS is defective.
1. ADF and ADF Cover are open.
2. ADF Sensor is disconnected.
3. ADF Sensor is defective.
1. Toner blocked in the Toner Cartridge.
(Shake the Toner Cartridge to loosen the contents)
1. Fuser Unit is not installed.
1. Drum Unit is not installed.
1. Drum Unit requires replacement.
1. Punch Cover is open.
2. Punch Cover Sensor is disconnected.
3. Punch Cover Sensor is defective.
447
DP-C405/C305/C265
FEB 2008