Panasonic DP-C305 Service Manual page 776

12.1.2.2.3. Job Offset
1. Outline
"Job offset" refers to the operation by which the machine delivers a set of sheets with them pulled
forward, or backward for sorting.
Switching between the forward, and backward directions is accomplished by using an aligning plate
(Front), and an aligning plate (Rear).
The sheet coming between the Delivery Rollers is fed onto the Processing Tray, and then fed toward
the stopper by the Paddle.
A swing guide is at the upper position while a sheet is being pulled onto the Processing Tray, or during
alignment. It is at the lower position during stack feeding, stack delivery, or stapling.
At power-on, the Finisher Controller PCB drives the Aligning Plate (Front) Motor (M4), and the Aligning
Plate (Rear) Motor (M5) to return the two aligning plates to their home positions.
Sensor
Aligning Plate (Front)
Home Position Sensor
Aligning Plate (Rear)
Home Position Sensor
Swing Guide Home
Position Sensor
Paddle Home Position
Sensor
Ver. 1.1
Symbol Connector
PI4 CN4-3
PI5 CN5-15
PI3 CN9-9
PI2 CN9-3
Alignment Plate (Front)
Motor (M4)
Aligning Plate
(Front)
Light-Shielding Plate
(Front)
Aligning Plate (Front) Home Position Sensor (PI4)
Function
Drives the Aligning Plate
(Front)
Drives the Aligning Plate
(Rear)
Drives the Swing Guide
Drive
Drives the Paddle (feeds
paper)
Table 2-003
Aligning plate (Rear)
Aligning plate (Rear)
home position sensor (PI5)
Aligning plate (Rear)
motor (M5)
Paper
Fig. 2-017
776
DP-C405/C305/C265
Motor
Aligning Plate
(Front) Motor
Aligning Plate
(Rear) Motor
Paddle Motor
Paddle Motor
Light-shielding plate
Symbol
M4
M5
M2
M2
FEB 2008