Oil Pan And Oil Pump Strainer Cleaning - Suzuki Swift Sport 2004 Service & Repair Manual

6) After fitting oil pan to cylinder block, run in securing
bolts and start tightening at the center: move wrench
outward, tightening one bolt at a time. Tighten bolts
and nuts to specified torque.
Tightening torque
Oil pan bolt (M6) (a): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
Oil pan bolt (M10) (c): 55 N·m (5.5 kgf-m, 40.0 lb-
ft)
Oil pan nut (e): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
7) Install new gasket and drain plug to oil pan.
Tighten drain plug to specified torque.
Tightening torque
Oil pan drain plug (b): 35 N·m (3.5 kgf-m, 25.5 lb-
ft)
8) Tighten transaxle stiffener bolts to specified torque.
Tightening torque
Transaxle stiffener bolt (d): 55 N·m (5.5 kgf-m,
40.0 lb-ft)
(d) (e) (c)
9) Install exhaust manifold stiffener (2) and exhaust
No.1 pipe (1) and heated oxygen sensor No.2
(connector color: green) (3) referring to "Exhaust
System Components in Section 1K".
3
(a)
(b)
I4RS0A150008-01
2
1
I4RS0A150003-01
Engine Lubrication System:
10) Install clutch housing lower plate (1).
11) Install oil level gauge.
12) Refill engine with engine oil referring to "Engine Oil
and Filter Change in Section 0B".
13) Verify that there is no engine oil leakage and exhaust
gas leakage at each connection.

Oil Pan and Oil Pump Strainer Cleaning

• Clean sealing surface between oil pan and cylinder
block.
Remove oil, old sealant, and dust from sealing
surface.
• Clean oil pump strainer screen (1).
1E-7
1
I4RS0A150004-01
S7RS0B1506006
I2RH0B150016-01