Specifications; Tightening Torque Specifications; Special Tools And Equipment; Special Tool - Suzuki Swift Sport 2004 Service & Repair Manual

6) Set timing light (1) to high-tension cord for No.1
cylinder and check that ignition timing is within
specification.
Initial ignition timing
Fixed with SUZUKI scan tool: 5 ± 3° BTDC (at
specified idle speed)
Ignition order
1 – 3 – 4 – 2

Special tool

(A): 09930–76420
10
1, (A)

Tightening Torque Specifications

Fastening part
Spark plug
Ignition coil bolt
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
Special Tool
09930–76420
Timing-light (dry cell type)
0
I3RB0A180004-01

Specifications

Special Tools and Equipment

7) If ignition timing is out of specification, check the
followings.
• CKP sensor
• CKP sensor plate
• CMP sensor
• CMP sensor rotor tooth of camshaft
• VSS
• Timing chain cover installation
8) After checking initial ignition timing, release ignition
timing fixation by using scan tool.
9) With engine idling (throttle opening at closed position
and vehicle stopped), check that ignition timing is
about 3° – 13° BTDC. (Constant variation within a
few degrees from 3° – 13° BTDC indicates no
abnormality but proves operation of electronic timing
control system.) Also, check that increasing engine
speed advances ignition timing.
If the check results are not satisfactory, check CKP
sensor and ECM.
Tightening torque
N⋅m kgf-m
25 2.5
10 1.0
SUZUKI scan tool
—
This kit includes following
items. 1. Tech 2, 2. PCMCIA
card, 3. DLC cable, 4. SAE
16/19 adapter, 5. Cigarette
cable, 6. DLC loop back
adapter, 7. Battery power
cable, 8. RS232 cable, 9.
RS232 adapter, 10. RS232
loop back connector, 11.
Storage case, 12.
Ignition System:
S7RS0B1807001
Note
lb-ft
18.0
7.5
S7RS0B1808001
1H-9