Suzuki Swift Sport 2004 Service & Repair Manual page 296

1D-11 Engine Mechanical:
2) Remove oil, old sealant, and dust from sealing
surfaces on cylinder head and cover. After cleaning,
apply sealant "A" to the following point.
• Cylinder head cover gasket (1) sealing surface
area (2) as shown.
"A": Water tight sealant 99000–31250
(SUZUKI Bond No.1207F)
• Timing chain cover (1) and cylinder head (2)
mating surface as shown.
"A": Water tight sealant 99000–31250
(SUZUKI Bond No.1207F)
3) Install cylinder head cover to cylinder head.
NOTE
When installing cylinder head cover, use care
so that cylinder head cover gasket or spark
plug hole gaskets will not get out of place or
fall off.
4) Tighten cylinder head cover bolts as follows.
a) Tighten cylinder head cover bolts to 3 N⋅m (0.3
kgf-m, 2.5 lb-ft) according to numerical order ("1"
through "7") as shown in figure.
b) In the same manner as in Step, a) tighten them
to 5 N⋅m (0.5 kgf-m, 4.0 lb-ft).
c) Retighten them by turning through 8 N⋅m (0.8
kgf-m, 6.0 lb-ft) in same manner as Step a).
Tightening torque
Cylinder head cover bolt (a): Tighten 3 N⋅m (0.3
I2RH0B140036-01
kgf-m, 2.5 lb-ft), 5 N⋅m (0.5 kgf-m, 4.0 lb-ft) and 8
N⋅m (0.8 kgf-m, 6.0 lb-ft) by the specified
procedure
5) Connect PCV hose (2) to PCV valve (3).
6) Connect breather hose (4).
7) Install oil level gauge (1).
I2RH0B140037-01
8) Install wire harness clamp to cylinder head cover.
9) Install ignition coil assemblies with high-tension cord
referring to "Ignition Coil Assembly (Including ignitor)
Removal and Installation in Section 1H".
10) Connect ignition coil couplers and clamp harness
securely.
11) Install cylinder head upper cover.
12) Install air cleaner case and resonator.
13) Connect negative cable at battery.
I3RH0B140016-01