Suzuki Swift Sport 2004 Service & Repair Manual page 208

1A-158 Engine General Information and Diagnosis:
DTC Confirmation Procedure
1) With ignition switch turned OFF, connect scan tool.
2) Turn ON ignition switch and clear DTC using scan tool.
3) Keep the accelerator pedal at idle position for 2 seconds.
4) Keep the accelerator pedal at fully depressed position for 2 seconds.
5) Repeat Step 3) and 4) for 3 times.
6) Check DTC.
DTC Troubleshooting
NOTE
• When measuring circuit voltage, resistance and/or pulse signal at ECM connector, connect the
special tool to ECM and/or the ECM connectors referring to "Inspection of ECM and Its Circuits".
• Upon completion of inspection and repair work, perform "DTC Confirmation Procedure" and
confirm that the trouble has been corrected.
Step
1 Was "Engine and Emission Control System Check"
performed?
2 Electric throttle body assembly system check
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Turn ON ignition switch, check each voltage of "TP
Sensor 1 Volt" and "TP Sensor 2 Volt" displayed on scan
tool when accelerator pedal is idle position and fully
depressed.
Is displayed each TP sensor value as described voltage in
"Scan Tool Data"?
3 Throttle actuator circuit check
1) Disconnect connector from electric throttle body with
ignition switch turned OFF.
2) Check for proper connection to electric throttle body at
"LT GRN/RED" and "LT GRN/BLK" wire terminals.
"LT GRN/BLK"
"LT GRN/RED"
3) Disconnect connectors from ECM.
4) Check for proper connection to ECM at "C37-45" and
"C37-44" terminals.
5) Measure resistance at the following connector terminals.
• Between "LT GRN/RED" wire terminal of electric
throttle body connector and "C37-45" terminal of ECM
connector
• Between "LT GRN/BLK" wire terminal of electric
throttle body connector and "C37-44" terminal of ECM
connector
Is each resistance below 5
Action
"WHT"
"BLK"
"RED"
"GRN"
I4RS0B110022-02
Ω
?
Yes
Go to Step 2.
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection in Section
00".
Go to Step 4.
No
Go to "Engine and
Emission Control
System Check".
Go to Step 3.
"LT GRN/RED" wire
and/or "LT GRN/BLK"
wire is open or high
resistance.