Suzuki Swift Sport 2004 Service & Repair Manual page 192

(rs416)
Table of Contents

Advertisement

1A-142 Engine General Information and Diagnosis:
DTC Troubleshooting
NOTE
• When measuring circuit voltage, resistance and/or pulse signal at ECM connector, connect the
special tool to ECM and/or the ECM connectors referring to "Inspection of ECM and Its Circuits".
• Upon completion of inspection and repair work, perform "DTC Confirmation Procedure" and
confirm that the trouble has been corrected.
Step
1
Was "Engine and Emission Control System Check"
performed?
2
Electric load current sensor power and ground circuit
check
1) Disconnect connector from electric load current sensor.
2) Check electric load current sensor circuit for the
following.
• Voltage between "BLK/WHT" wire terminal of electric
load current sensor connector and vehicle body
ground is 10 – 14 V with ignition switch turned ON
• Resistance between "BLK/ORN" wire terminal of
electric load current sensor connector and vehicle
body ground is less than 2 Ω
Are they in good condition?
3
Electric load current sensor output circuit check
1) Disconnect connectors from ECM.
2) Check electric load current sensor circuit for the
following.
• Resistance between "PNK/BLU" wire terminal of
electric load current sensor connector and "C37-23"
terminal of ECM connector is less than 2 Ω
• Resistance between "PNK/BLU" wire terminal of
electric load current sensor connector and vehicle
body ground is infinity
• Voltage between "PNK/BLU" wire terminal of electric
load current sensor connector and vehicle body
ground is 0 V with ignition switch turned ON
Are they in good condition?
4
Electric load current sensor check
1) Check for electric load current sensor output referring to
"Electric Load Current Sensor On-Vehicle Inspection in
Section 1C".
Is check result satisfactory?
Action
Yes
Go to Step 2.
Go to Step 3.
Go to Step 4.
Substitute a known-
good ECM and recheck.
No
Go to "Engine and
Emission Control
System Check".
Repair or replace
defective wire.
Repair or replace
defective wire.
Faulty electric load
current sensor.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Swift sport 2008Swift 2005

Table of Contents