Texas Instruments TMS320C6711D User Manual page 31

PIN
NO.
SIGNAL SIGNAL
TYPE † TYPE †
NAME
GDP/
ZDP
RSV C12
RSV D12
RSV A5
RSV N2
RSV N1
RSV B5
RSV D7
RSV A12
RSV B11
† I = Input, O = Output, Z = High impedance, S = Supply voltage, GND = Ground, A = Analog signal (PLL Filter)
‡ IPD = Internal pulldown, IPU = Internal pullup. [To oppose the supply rail on these IPD/IPU signal pins, use external pullup or pulldown resistors
no greater than 4.4 kΩ and 2.0 kΩ, respectively.]
FLOATING POINT DIGITAL SIGNAL PROCESSOR
Terminal Functions (Continued)
IPD/ IPD/
IPU ‡ ‡
RESERVED FOR TEST
Reserved (leave unconnected, do not connect to power or ground).
IPU
On this device, this pin does not have an IPU.
On this device, this pin does not have an IPU. For proper device operation, the D12 pin must
IPU
be externally pulled down with a 10-kΩ resistor.
IPU Reserved (leave unconnected, do not connect to power or ground)
Reserved. For proper device operation, this pin must be externally pulled up with a 10-kΩ
resistor.
Reserved. For proper device operation, this pin must be externally pulled up with a 10-kΩ
resistor.
Reserved (leave unconnected, do not connect to power or ground)
IPD Reserved (leave unconnected, do not connect to power or ground)
Reserved. [For new designs, it is recommended that this pin be connected directly to CV DD
(core power). For old designs, this can be left unconnected.
Reserved [For new designs, it is recommended that this pin be connected directly to V ss
(ground). For old designs, this pin can be left unconnected.
•
POST OFFICE BOX 1443 HOUSTON, TEXAS 77251−1443
TMS320C6711D
SPRS292A − OCTOBER 2005 − REVISED NOVEMBER 2005
DESCRIPTION DESCRIPTION
31