Driveshafts Disassembly - Honda 2002 Accord Manual

Driveshafts Disassembly
Special Tools Required
• Threaded adapter, 24 x 1.5 mm 07XAC-001020A
• Slide hammer, commercially available
• Boot band pincer, commercially available
Inboard J o i n t Side:
1. Remove the set ring (A) from the inboard joint.
2. Remove the boot bands. Take care not to damage
the boot and dynamic damper.
• If the boot band is welded type (A), cut the boot
band (B).
• If the boot band is a double loop type (C), lift up
the band bend (D), and push it into the clip (E).
• If the boot band is a low profile type (F), pinch
and remove the boot band with a commercially
available boot band pincer (G).
Welded Type
Double Loop Type
3. Make a mark (A) on each roller (B) and inboard joint
(C) to identify the locations of rollers and grooves
in the inboard joint. Then remove the inboard joint
on the shop towel (D). Be careful not to drop the
rollers when separating them from the inboard
joint.
C
(cont'd)
16-5