Heating
Blower Unit Removal and Installation
S R S components are located in this area. Review the
S R S components locations, precautions, and
procedures in the S R S section before performing
repairs or service (see page 23-28).
1. Make sure you have the anti-theft code for the radio,
then write down the frequencies for the radio's
preset buttons.
2. Disconnect the negative cable from the battery.
3. Remove the dashboard (see page 20-90).
4. With air conditioning; remove the evaporator (see
page 21-46).
5. Without air conditioning; remove the self-tapping
screws, the moutning nut, the mounting bolts and
the heater duct.
6 x 1.0 m m
9 . 8 N m ( 1 . 0 k g f m , 7 . 2 I b f f t )
6. Disconnect the connectors (A) from the blower
motor, the blower resistor and the recirculation
control motor, then remove the wire harness clip
(B). Remove the mounting nuts, the mounting bolt
and the blower unit (C).
6 x 1 . 0 m m
9 . 8 N m (1.0 k g f m , 7 . 2 I b f f t )
6 x 1 . 0 m m
9 . 8 N m (1.0 k g f m , 7 . 2 Ibf-ft)
7 . Install the unit in the reverse order of removal, and
note these items:
• Make sure that there is no air leakage.
• Enter the anti-theft code for radio, then enter the
customer's radio station presets.
21-26