Carrier Bearing Preload Inspection - Honda 2002 Accord Manual

Carrier Bearing Preload Inspection
Special Tools Required
•Driver 07749-0010000
• Driver attachment 07HAD-SF10100
• Preload inspection tool 07HAJ-PK40201
NOTE: If the transmission housing, torque converter
housing, differential carrier, tapered roller bearing,
outer race, or thrust shim were replaced, the bearing
preload must be adjusted.
1. Remove the bearing outer race (A), thrust washer
(B) and thrust shim (C) from the transmission
housing (D) by heating the housing to about 212°F
(100°C) with a heat gun (E). Do not heat the housing
more than 212°F (100°C).
NOTE: Let the transmission housing cool to room
temperature before adjusting the bearing preload.
2. Replace the tapered roller bearing when the outer
race is to be replaced.
3. Do not use a shim on the torque converter housing
side.
0 ©
4. Select the 2.60 mm (0.102 in.) thrust shim from the
middle of the table below.
T H R U S T SHIM, 76 mm
No. Part Number Thickness
S 41438-PX4-700 2.05 mm (0.081 in.)
T
41439-PX4-700 2.01 mm (0.083 in.)
U 41440-PX4-700
2.15 mm (0.085 in.)
A 41441-PK4-000
2.20 mm (0.087 in.)
B 41442-PK4-000
2.25 mm (0.089 in.)
C 41443-PK4-000
2.30 mm (0.091 in.)
D 41444-PK4-000
2.35 mm (0.093 in.)
E
41445-PK4-000
2.40 mm (0.094 in.)
F 41446-PK4-000 2.45 mm (0.096 in.)
G
41447-PK4-000 2.50 mm (0.098 in.)
H 41448-PK4-000 2.55 mm (0.100 in.)
I 41449-PK4-000 2.60 mm (0.102 in.)
J 41450-PK4-000
2.65 mm (0.104 in.)
K 41451-PK4-000 2.70 mm (0.106 in.)
L 41452-PK4-000
2.75 mm (0.108 in.)
M 41453-PK4-000
2.80 mm (0.110 in.)
N 41454-PK4-000
2.85 mm (0.112 in.)
O 41455-PK4-000
2.90 mm (0.114 in.)
P
41456-PK4-000
2.95 mm (0.116 in.)
Q 41457-PK4-000 3.00 mm (0.118 in.)
R 41458-PK4-000 3.05 mm (0.120 in.)
(cont'd)
14-205