Honda 2002 Accord Manual page 661

30
7 , Cut the lock tabs (A) of each shaft locknut (B) using
a chisel ( C ) . Then remove the locknuts and conical
spring washers f r o m each shaft.
NOTE:
• Mainshaft locknut has left-hand threads.
• Clean the old locknuts; they are used to install the
press fit idler gears on the mainshaft and
secondary shaft, and the park gear and bearing
hub on the countershaft.
• Keep all of the chiseled particles out of the
transmission.
8. Remove the special tool (mainshaft holder) f r o m
the mainshaft.
9. Remove the mainshaft idler gear (A) and the
secondary shaft idler gear (B) with a puller (C).
B C
10. W i t h the puller, remove the bearing hub (D) f r o m
the countershaft, then remove the countershaft
idler gear (E) and bearings.
11. Remove the park gear (F) w i t h the puller.
12. Remove the park p a w l , spring, shaft, and shaft stop.
13. Remove the park lever f r o m the control shaft.
14. Remove the line bolts, then remove the ATF cooler
lines.
14-151