Countershaft Disassembly, Inspection, And Reassembly - Honda 2002 Accord Manual

Countershaft Disassembly, Inspection, and Reassembly
1. Remove the locknut, and take off components d o w n to the reverse selector hub.
2. Remove the reverse selector hub, 3rd gear, and 1st gear (see page 14-172).
3. Check the bearing in the bearing hub for wear and rough m o v e m e n t If the bearing is w o r n or damaged, replace it
(see page 14-174).
4. Inspect the thrust needle bearing and the needle bearing for galling and rough m o v e m e n t .
5. Check the splines for excessive wear and damage.
6. Check the shaft bearing surfaces for scoring and excessive wear.
7. Lubricate all parts w i t h ATF, and reassemble the shaft and gears.
8. Install the conical spring washer, idler gear, reverse selector, reverse selector hub, and distance collar in the
direction s h o w n .
LOCKNUT (FLANGE NUT)
Replace.
26 N m (23.0 k g f m , 166 I b f f t ) - 0 —
167 N m (17.0 k g f m , 123 I b f f t )
14-171