Safety Indicator System
Safety Indicator Input Test
SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the
SRS section before performing repairs or service (see page 23-28).
1. Remove the gauge assembly (A) from the dashboard (see page 22-68), and disconnect the 22P connector (B) and
the 14P connector (C) from the gauge assembly.
* W i t h o u t k e y l e s s e n t r y s y s t e m
2. Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, go to step 3.
3. Make these input tests at the connectors.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, the printed circuit board must be faulty; replace it.
22-76